beautypg.com

Locks and security – FORD 2002 F-150 v.1 User Manual

Page 115

background image

If you wish to erase your personal code, use the following instructions:

Erasing personal code

1. Enter factory set code.

2. Press 1/2 control within five
seconds of step one.

3. Press 7/8 control and 9/0 control
at the same time within five seconds
of step 2.

The system will now only respond
to the factory set code.

Anti-scan feature

The keyless entry pad is disabled for
1 minute after 7 unsuccessful
attempts at entering a valid key
code. The keypad will flash during
this 1 minute mode. However, the 7/8 and 9/0 controls will still lock the
vehicle.

Anti-scan will turned off after:
• one minute of keypad inactivity
• the keyfob UNLOCK button is pressed.
• the ignition is turned to the ON position

Unlocking the doors with the keyless entry system

To unlock the driver door, enter either the factory set code or the
personal code (each digit must be pressed within five seconds of the
prior digit). The interior lamps will also illuminate.

To unlock all doors, enter the factory set code or personal code (driver
door unlocks) and press the 3/4 control within five seconds.

Locking the doors with the keyless entry system

It is not necessary to enter the factory or personal code prior to locking
all doors. To lock the doors:
• Press the 7/8 control and the 9/0 control at the same time.

1 2

3 4

5 6

7 8

9 0

1 2

3 4

5 6

7 8

9 0

Locks and Security

115