FORD 2004 Explorer v.2 - Manual (Page 63)

Erasing HomeLink ா buttons
To erase the three programmed
buttons (individual buttons cannot
be erased):
• Press and hold the two outer
HomeLink
௡ buttons until the red
indicator light begins to
flash-after 20 seconds. Release
both buttons. Do not hold for
longer that 30 seconds.
HomeLink
௡ is now in the train (or
learning) mode and can be programmed at any time beginning with step
2 in the “Programming” section.
Reprogramming a single HomeLink
ா button
To program a device to HomeLink
௡ using a HomeLink௡ button previously
trained, follow these steps:
1. Press and hold the desired HomeLink
௡ button. Do NOT release the
button.
2. The red indicator light will begin to flash after 20 seconds. Without
releasing the HomeLink
௡ button, follow step 2 in the “Programming”
section.
For questions or comments, contact HomeLink
௡ at www.homelink.com
or 1–800–355–3515.
ELECTRONIC COMPASS/TEMPERATURE DISPLAY (IF EQUIPPED)
OUTSIDE AIR TEMPERATURE
The outside temperature display is
contained in the instrument cluster
and displays all the time. If
equipped with the DEATC climate
control system, the outside
temperature will be displayed there.
To turn the display off or change the display from English to metric see
your dealer.
Compass
The compass reading may be affected when you drive near large
buildings, bridges, power lines and powerful broadcast antennas.
Magnetic or metallic objects placed in, on or near the vehicle may also
affect compass accuracy.
2004 Explorer (exp)
Owners Guide (post-2002-fmt)
USA English (fus)
Driver Controls
63