beautypg.com

Driver controls – FORD 2004 Explorer v.2 User Manual

Page 61

background image

3. Simultaneously press and hold
both the HomeLink

௡ and hand-held

transmitter button. Do not release
the buttons until step 4 has been
completed.

Some entry gates and garage door
openers may require you to replace
step 3 with procedures noted in the
“Gate Operator and Canadian
Programming” section for Canadian
residents.

4. The red light will flash slowly and then rapidly. Release both buttons
when the red light flashes rapidly. (The rapid flashing light indicates
acceptance of the hand-held transmitters’ radio frequency signals.)

5. Press and hold the just-trained HomeLink

௡ button and observe the red

light. If the light is a constant red, programming is complete and your
device should activate when the HomeLink

௡ button is pressed and

released. Note: To program the remaining two HomeLink

௡ buttons,

begin with step 2 in the “Programming” section — do not repeat step 1.

Note: If the red light blinks rapidly for two seconds and then turns to a
continuous red, proceed with steps 6 through 8 to complete
programming of a rolling code equipped device.

6. At the garage door opener receiver (motor-head unit) in the garage,
locate the “learn” or “smart” button (usually near where the hanging
antenna wire is attached to the unit).

7. Press and release the “learn” or “smart” button. (The name and color
of the button may vary by manufacturer.)

Note: There are 30 seconds in which to initiate step eight.

8. Return to the vehicle and firmly press, hold for two seconds and
release the HomeLink

௡ button. Repeat the press/hold/release sequence

again, and, depending on the brand of the garage door opener (or other
rolling code equipped device), repeat this sequence a third time to
complete the programming.

HomeLink

௡ should now activate your rolling code equipped device. To

program additional HomeLink

௡ buttons begin with step 2 in the

“Programming” section. For questions or comments, please contact
HomeLink at www.homelink.com or 1–800–355–3515.

2004 Explorer (exp)
Owners Guide (post-2002-fmt)
USA English
(fus)

Driver Controls

61