FORD 2005 Freestar v.2 - Manual (Page 76)

Programming
Do not program HomeLink
௡ with the vehicle parked in the garage.
Note: Your vehicle may require the ignition switch to be turned to the
ACC position for programming and/or operation of the HomeLink
௡. It is
also recommended that a new battery be placed in the hand-held
transmitter of the device being programmed to HomeLink
௡ for quicker
training and accurate transmission of the radio-frequency signal.
1. Press and hold the two outside
buttons releasing only when the
indicator light begins to flash after
20 seconds. Do not repeat Step 1
to program additional hand-held
transmitters to the remaining two
HomeLink
௡ buttons. This will erase
previously programmed hand-held
transmitter signals into HomeLink
௡.
2. Position the end of your
hand-held transmitter 1–3 inches (2–8 cm) away from the HomeLink
௡
button you wish to program (located on your visor) while keeping the
indicator light in view.
3. Simultaneously press and hold
both the HomeLink
௡ and hand-held
transmitter button. Do not release
the buttons until Step 4 has
been completed.
Some entry gates and garage door
openers may require you to replace
Step 3 with procedures noted in the
“Gate Operator and Canadian Programming” in this section for Canadian
residents.
4. The indicator light will flash slowly and then rapidly. Release both
buttons when the indicator light flashes rapidly. (The rapid flashing light
indicates acceptance of the hand-held transmitters’ radio frequency
signals.)
5. Press and hold the just-trained HomeLink
௡ button and observe the
indicator light. If the light is constant, programming is complete and your
device should activate when the HomeLink
௡ button is pressed and
released. Note: To program the remaining two HomeLink
௡ buttons,
begin with Step 2 in the “Programming” section — do not repeat Step 1.
2005 Freestar (win)
Owners Guide (post-2002-fmt)
USA_English (fus)
Driver Controls
76