beautypg.com

Disabling psd power operation, Safety/obstructions, Resetting the psd – FORD 2005 Freestar v.2 User Manual

Page 64: Driver controls

background image

Disabling PSD power operation

Pressing the Power Door Lockout Control to the OFF position prevents
power operation of the PSD using the rear seat control(s), inside or
outside handle or by manually moving the door. With the PSD rear
controls disabled, the door(s) can be opened manually with the inside or
outside handles. With the Power Door Lockout control in the OFF
position, the overhead console right and left hand controls and the
Remote Entry System remain functional. Disabling the PSD may be
desirable to prevent power operation of the door by rear seat passengers
or if manual operation of the door is desired or necessary when the
vehicle is stopped or parked on a steep downhill grade.

Refer to the Manual operation of the sliding door section in this
chapter for more information.

With the child safety lock engaged, the inside handle operation will
always be disabled regardless of the position of the Power Door Lockout
control. Refer to the Sliding door child safety lock section in this
chapter for more information. The trim mounted rear seat control and
the outside handle remain functional for power operation.

Safety/Obstructions

If anything obstructs the Power Sliding Door while it is power closing or
opening, the door will automatically reverse or stop depending on the
position of the door, provided it meets sufficient resistance.

Resetting the PSD

The power sliding door may operate incorrectly or not at all because of
the following conditions:
• a low voltage or dead battery
• the door is left opened for more than 6 hours
• the battery is disconnected
• the PSD Passenger compartment fuse panel fuse (fuse #11) is

removed or blown. Refer to Fuses and relays in the Roadside
Emergencies
chapter.

If any of the above conditions has occurred, perform the following steps
to reset the PSD so that electronics can relearn the open and closed
positions:

1. Check to see if PSD is securely closed.

2. Make sure the gearshift is in (P) Park.

3. Push the PSD control on the overhead console to open the door.

2005 Freestar (win)
Owners Guide (post-2002-fmt)
USA_English
(fus)

Driver Controls

64