FORD 2005 Freestar v.2 - Manual (Page 104)

The keypad can be operated with the factory set 5–digit entry code; this
code is located:
• on the owner’s wallet card in the glove box,
• marked on the passenger compartment fuse panel (located below and
to the left of the steering, near the brake pedal),
• and is available from your
authorized dealer.
You can also create your own 5–digit
personal entry code.
When pressing the controls on the
keypad, press the middle of the
controls to ensure a good activation.
Programming a personal entry code
To create your own personal entry code(s):
1. Enter the factory set code. Note: The driver’s door will unlock.
2. Within five seconds press and release the 1
• 2 on the keypad. Note:
The lock motors will cycle, locked then unlocked.
3. Enter your personal 5-digit code. Each number must be entered
within five seconds of each other.
4. Enter a sixth digit if you wish to have the personal entry code recall
memory position Driver 1 or Driver 2 (if equipped with the memory
seat/side view mirrors/adjustable pedals feature). Note: The lock motors
will cycle, locked then unlocked.
• Press 1 • 2 to recall the Driver 1 position.
• Press 3 • 4 to recall the Driver 2 position.
5. After five seconds of keypad inactivity, programming mode is exited.
All of the vehicle doors will lock and unlock to confirm the code has
been stored. Each memory feature driver position (Driver 1 or Driver 2)
can be associated with only one personal code. The factory-set code
cannot be associated with a memory recall position.
You can program up to three personal codes; these codes do not replace
the factory-set code.
2005 Freestar (win)
Owners Guide (post-2002-fmt)
USA_English (fus)
Locks and Security
104