FORD 2007 Explorer Sport Trac v.1 - Manual (Page 99)

(refer to the Illuminated entry feature later in this section), if the
control on the overhead lamp is not set to the off position and the
perimeter alarm system (if equipped) will deactivate.
Switching from two step to one step door unlocking
Your vehicle comes with two step unlocking enabled. Unlocking can be
switched between two step and one step door unlocking by pressing and
holding both the
and buttons simultaneously on the remote entry
transmitter for approximately 4 seconds. The hazard lamps will flash
twice to indicate that the vehicle has switched to one step unlocking.
Repeat the procedure to switch back to two-step unlocking.
Locking the doors
1. Press and release to lock all the doors. The lamps will flash. Note:
If any door is not closed properly, the lamps will not flash until all doors
are closed.
2. Press and release again within three seconds to confirm that all the
doors are closed and locked. Note: The doors will lock again and the
horn will make two quick chirps and the lamps will not flash until all the
doors are closed.
Note: If any door is not closed properly, the horn will make two quick
chirps.
Sounding a panic alarm
Press to activate the alarm. The horn will sound and the parklamps
will flash for a maximum of 3 minutes. Press again or turn the ignition to
the 3 (ON) position to deactivate, or wait for the alarm to timeout in
3 minutes.
Note: The panic alarm will only operate when the ignition is in the
1 (OFF/LOCK) position.
Replacing the battery
The remote entry transmitter uses one coin type three-volt lithium
battery CR2032 or equivalent.
2007 07+ Explorer Sport Trac (esp)
Owners Guide (post-2002-fmt)
USA (fus)
Locks and Security
99