FORD 2007 Explorer Sport Trac v.1 - Manual (Page 58)

3. Window is moving up and is between vent and closed
4. Window is moving down and is between vent and down
5. Window is moving up and is between down and vent
The “down” command is the only one allowed after the ignition has been
switched to OFF or ON while the window is moving.
Bounce-Back
When the back window is moving upward and an obstacle interferes with
the window’s movement, the back window will reverse direction and
move toward the fully open position. This is known as “bounce-back”.
Security Override
If, during a bounce-back condition, the control is held in the (“up”)
direction for at least two seconds, the back window will travel up
with no bounce-back protection. If the control is released before the
window reaches fully closed or the ignition is switched to OFF or ON,
the back window will reverse direction with bounce-back re-enabled.
The following are possible reasons for using the security override:
• Ice on the window causing a restriction.
• Window unexpectedly reverses.
Position recovery mode
If the motor loses or has an invalidated position, the motor will respond
to switch inputs by moving .6 in. (15 mm) each switch command in the
up direction only. Down will be a one touch down operation. If the
window is stalled in the down position and there are no other system
faults, the motor shall relearn its position and resume full functionality. If
there is a hall effect signal loss, then the window will remain in its .6 in.
(15 mm) travel each switch command. This will allow the customer to
ЉinchЉ his window up to the fully closed position. Once the window has
reached the full closed, the window should again operate in “normal”
operation mode. If the window still does not operate correctly, see your
dealer for service.
2007 07+ Explorer Sport Trac (esp)
Owners Guide (post-2002-fmt)
USA (fus)
Driver Controls
58