beautypg.com

Fcc and rss-210 industry canada compliance, Manual liftgate (if equipped), Driver controls – FORD 2010 Edge v.2 User Manual

Page 95

background image

To erase programming on the Car2U

௡ system (individual buttons cannot

be erased), use the following procedure:

1. Firmly press the two outside
Car2U

௡ system buttons

simultaneously for approximately
20 seconds until the indicator lights
begin to blink rapidly. The indicator
lights are located directly above the
buttons.

2. Once the indicator lights begin to
blink, release your fingers from the
buttons. The codes for all buttons
are erased.
If you sell your vehicle equipped with the Car2U

௡ system, it is

recommended that you erase the programming for security reasons.

FCC and RSS-210 Industry Canada Compliance
The Car2U

௡ system complies with Part 15 of the FCC rules and with

RSS-210 of Industry Canada. Operation is subject to the following two
conditions: (1) This device may not cause harmful interference, and (2)
This device must accept any interference received including interference
that may cause undesired operation.
Changes and modifications to the Car2U

௡ system transmitter by other

than an authorized service facility could void authorization to use the
equipment.

MANUAL LIFTGATE (IF EQUIPPED)
The liftgate area is only intended for cargo, not passengers.

To open the liftgate, press the
button located in the top of the
liftgate pull cup handle to unlatch
the liftgate, then pull on the outside
handle.
• Exercise care when opening or

closing the liftgate in a garage or
other enclosed area. The liftgate
could be damaged against a
garage door, low ceiling or wall.

• Do not hang anything (bike rack, etc.) from the spoiler/glass or

liftgate. Doing so could cause serious damage to the liftgate and its
components.

Driver Controls

95

2010 Edge (edg)
Owners Guide, 2nd Printing
USA
(fus)