FORD 2010 Edge v.2 - Manual (Page 94)

3. To input these positions into the
Car2U
௡ system, simultaneously
press all three Car2U
௡ system
buttons for a few seconds and then
release to put the device into
programming mode. The indicator
lights will blink slowly. Within
2.5 minutes enter your
corresponding DIP switch settings
from left to right into your Car2U
௡ system by pressing and releasing the
buttons corresponding to the settings you circled.
4. After inputting switch settings, simultaneously press and release all
three Car2U
௡ system buttons. The indicator lights will turn on.
5. Press and hold the Car2U
௡
system button you would like to use
to control the garage door.
Immediately (within 1 second)
release the button once the garage
door moves. During this time the
selected button indicator light will
blink slowly. Do not release the
button until you see the garage door move. Most garage doors open
quickly. You may need to hold the button from 5–55 seconds before
observing movement of the garage door.
6. The indicator light will (begin to) blink rapidly until programming is
complete. If your garage door opener does not operate following these
steps, repeat Steps 2 through 6. Otherwise, call the toll-free Car2U
௡ help
line at 1-866-57Car2U (1-866-572-2728).
After successful programming, you will be able to operate your Car2U
௡
system by pressing the button you programmed to activate the opener.
The indicator light above the selected button will turn on to confirm that
the Car2U
௡ system is responding to the button command.
Erasing the Car2U ா Home Automation System buttons
Note: The system allows for three devices to be programmed. If you
need to change or replace any of the three devices after it has been
initially programmed, it will be necessary to erase the current settings
using the procedure below and then reprogramming all of the devices
being used.
Driver Controls
94
2010 Edge (edg)
Owners Guide, 2nd Printing
USA (fus)