beautypg.com

Brake fluid, Transmission fluid, Checking automatic transmission fluid – FORD 2010 Edge v.2 User Manual

Page 303: Maintenance and specifications

background image

1. Start the engine and let it run
until it reaches normal operating
temperature (the engine coolant
temperature gauge indicator will be
near the center of the normal area
between H and C).

2. While the engine idles, turn the
steering wheel left and right several
times.

3. Turn the engine off.

4. Check the fluid level in the
reservoir. It should be between the
MIN and MAX lines. Do not add
fluid if the level is in this range.

5. If the fluid is low, add fluid in
small amounts, continuously
checking the level until it reaches
the range between the MIN and
MAX lines. Be sure to put the cap
back on the reservoir. Refer to
Maintenance product specifications and capacities in this chapter for
the proper fluid type.

BRAKE FLUID

The fluid level will drop slowly as
the brakes wear, and will rise when
the brake components are replaced.
Fluid levels between the MIN and
MAX lines are within the normal
operating range; there is no need to
add fluid. If the fluid levels are
outside of the normal operating
range, the performance of the
system could be compromised; seek
service from your authorized dealer
immediately.
TRANSMISSION FLUID

Checking automatic transmission fluid
Refer to your scheduled maintenance information for scheduled
intervals for fluid checks and changes. Your transmission does not

Maintenance and Specifications

303

2010 Edge (edg)
Owners Guide, 2nd Printing
USA
(fus)