beautypg.com

Compass zone/calibration adjustment, Instrument cluster – FORD 2010 Crown Victoria v.1 User Manual

Page 24

background image

Compass zone/calibration adjustment

1. Determine your magnetic zone by
referring to the zone map.

2. Turn ignition to the on position.

3. Start the engine.

4. Press SETUP to reach the
Compass/Odometer function.

5. Press SELECT to show COMPASS
ZONE PRESS SELECT TO
CHANGE.

6. Press the SELECT control
repeatedly until the correct zone setting for your geographic location is
displayed on the message center. The range of zone values are from 01
to 15 and “wraps” back to 01.

7. To exit the zone setting mode, and to “lock in” your change, press and
release the SETUP control.

Perform compass calibration in an open area free from steel structures
and high voltage lines. For optimum calibration, turn off all electrical
accessories (heater/air conditioning, wipers, etc.) and make sure all
vehicle doors are shut.

8. Press the SELECT control to start the compass calibration function.

9. Slowly drive the vehicle in a circle (less than 3 mph [5 km/h]) until
the CIRCLE SLOWLY TO CALIBRATE COMPASS display changes to
COMPASS CALIBRATION COMPLETED. It will take up to five circles to
complete calibration.

10. The compass is now calibrated.

OIL LIFE START VALUE PRESS SELECT TO CHANGE

Press SELECT to change the oil life start value. OIL LIFE START VALUE
SET TO XXX% will be displayed.

To reset the oil monitoring system to 100% after each oil change
(approximately 7,500 miles [12,000 km] or six months) perform the
following:

1. Press and hold the RESET control for two seconds and release. Oil life
is set to 100% and “OIL LIFE XXX% HOLD RESET IF NEW OIL” is
displayed.

2. Press and hold the RESET control for three seconds and release. Oil
life is set to 100% and “OIL LIFE START VALUE SET TO XXX%” is
displayed.

1

2

3

4

5

6

7 8 9 1011

12

13

14

15

Instrument Cluster

24

2010 Crown Victoria (cro)
Owners Guide, 1st Printing
USA
(fus)