Relays, Changing a flat tire, Changing tires – FORD 2010 Crown Victoria v.1 User Manual
Page 199: Roadside emergencies
Fuse/Relay
Location
Fuse Amp
Rating
Protected Circuits
208
—
Not used
209
1
⁄
2
ISO relay
Horn
301
Full ISO relay Starter
302
Full ISO relay Air compressor (non-Police vehicles
only), RUN/ACC relay (Police vehicles
only)
303
Full ISO relay Blower
304
Full ISO relay Rear defrost relay
501
—
Not used
502
Diode
PCM
503
—
Not used
601
20A Circuit
breaker
Power seats, Lumbar, Decklid (Police
vehicles only)
602
20A Circuit
breaker
RUN/ACC relay feed – Windows, Decklid
(Police vehicles only)
* Mini fuse ** Cartridge fuse
Relays
Relays are located in the power distribution box and should be replaced
by an authorized dealer.
CHANGING A FLAT TIRE
If you get a flat tire while driving:
• do not brake heavily.
• gradually decrease the vehicle’s speed.
• hold the steering wheel firmly.
• slowly move to a safe place on the side of the road.
Your vehicle may be equipped with a conventional spare tire that is
different in one or more of the following: type, brand, size, speed rating
and tread design. If this is the case, this dissimilar spare tire is still rated
for your vehicle loads (GAWR and GVWR). This temporary spare tire is
not equipped with a Tire Pressure Monitor System (TPMS) sensor.
Note: The tire pressure monitoring system (TPMS) indicator light will
illuminate when the spare is in use. To restore the full functionality of
Roadside Emergencies
199
2010 Crown Victoria (cro)
Owners Guide, 1st Printing
USA (fus)