Engine oil, Checking the engine oil, Maintenance and specifications – FORD 2011 Fiesta v.1 User Manual
Page 292
To replace the wiper blades:
1. Pull the wiper arm away from the
windshield.
2. Press the locking button (1).
3. Remove the wiper blade (2).
Note: Make sure the wiper blade locks into place.
ENGINE OIL
Checking the engine oil
Refer to the scheduled maintenance information for the appropriate
intervals for checking the engine oil.
1. Make sure the vehicle is at normal operating temperature and parked
on level ground.
2. Turn the engine off and wait 15 minutes for the oil to drain into the
oil pan.
3. Set the parking brake and ensure the gearshift is securely latched in
1st gear.
4. Open the hood, then locate and carefully remove the engine oil level
dipstick.
5. Wipe the dipstick clean. Insert the dipstick fully, then remove it again.
• If the oil level is between the MIN and MAX marks, the oil level is
acceptable. DO NOT ADD OIL.
• If the oil level is below the MIN
mark, add enough engine oil to
raise the level within the MIN and
MAX range. Refer to Adding
engine oil in this chapter.
• Oil levels above MAX mark
may cause engine damage. If
the engine is overfilled, some oil
must be removed from the engine by an authorized dealer.
6. Put the dipstick back in and ensure it is fully seated.
1
2
MÁX
.
MÍN.
Maintenance and Specifications
292
2011 Fiesta (fie)
Owners Guide, 1st Printing
USA (fus)