beautypg.com

Replacing tail/brake/turn signal lamp bulbs, Lights – FORD 2011 Crown Victoria v.2 User Manual

Page 58

background image

5. Rotate the bulb socket
counterclockwise and remove from
lamp assembly.

6. Carefully pull bulb straight out of
the socket and push in the new bulb
until it snaps, locking it into
position.

7. To complete installation, follow
the removal procedure in reverse
order.

Replacing tail/brake/turn signal lamp bulbs

The tail lamp and brake/turn signal lamp bulbs are located in the tail
lamp assembly. Follow the same steps to replace either bulb.

1. Make sure the headlamp switch is
in the off position, then open the
trunk and remove the retainer.

2. Carefully pull the carpet away to
expose the lamp assembly hardware.

3. Remove three nuts and the lamp
assembly from the vehicle.

4. Remove the bulb socket by
rotating it counterclockwise, then
pulling it out of the lamp assembly.

5. Pull the bulb from the socket and
push in the new bulb.

6. Install the bulb socket into the
lamp assembly by rotating it
clockwise.

7. Install the lamp assembly on the
vehicle with three nuts ensuring the
nuts are flush with the body to
prevent water from entering the trunk.

Lights

58

2011 Crown Victoria (cro)
Owners Guide, 2nd Printing
USA
(fus)