beautypg.com

Gate operator & canadian programming, Driver controls – FORD 2012 Focus v.5 User Manual

Page 148

background image

2. Return to your car.

3. Press and hold the function
button you want to program for
2 seconds, then release. Repeat this
step. Depending on the brand of
garage door opener you may need
to repeat this sequence a third time.

To program additional buttons
repeat steps one through four.

For questions or comments, please contact HomeLink

௡ at

www.homelink.com or 1-800-355-3515.

Gate Operator & Canadian Programming

During programming, your
hand-held transmitter may
automatically stop transmitting —
not allowing enough time for
HomeLink

௡ to accept the signal

from the hand-held transmitter.

After completing Step 1 outlined in
the Programming section, replace
Step 2 with the following:

Note: If programming a garage door opener or gate operator, it is
advised to unplug the device during the “cycling” process to prevent
overheating.
• Continue to press and hold the HomeLink௡ button (note Step 2 in the

Programming section) while you press and release —

every two

seconds (“cycle”) your hand-held transmitter until the frequency
signal has been accepted by the HomeLink

௡. The indicator light will

flash slowly and then rapidly after HomeLink

௡ accepts the radio

frequency signal.

• Proceed with Step 3 in the Programming section.

Driver Controls

148

2012 Focus (foc)
Owners Guide, 5th Printing
USA
(fus)

This manual is related to the following products: