Navigation system (if equipped), Setting a destination, Navigation system – FORD 2013 Focus v.1 User Manual
Page 439: Myford touch ா (if equipped) 439

NAVIGATION SYSTEM (IF EQUIPPED)
Note: The navigation SD card must be in the SD card slot to operate the
navigation system. If you need a replacement SD card, see your
authorized dealer.
Note: The SD card slot is spring-loaded. To remove the SD card, just
push the card in and release it. Do not attempt to pull the card out to
remove it; this could cause damage.
Your navigation system is comprised of two main features, destination
mode and map mode.
To set a destination, press the green corner of your touchscreen, then
the Dest button when it appears. See Setting a destination later in this
chapter.
To view the navigation map and the vehicle’s current location, touch the
green bar in the upper right hand corner of the touchscreen, or press
Dest > Map. See Map mode later in this chapter.
Setting a Destination
Press the green corner of your touchscreen, then the Dest button when
it appears. Choose any of the following:
Destination Selections
My Home
Street Address
Favorites
Intersection
Previous Destinations
City Center
Point of Interest
Map
Emergency
Edit Route Cancel Route
Previous Starting Point
Freeway Entrance/Exit
Latitude/Longitude
1. Enter the necessary information into the highlighted text fields (in any
order). For address destination entry, the Go! button appears once all
the necessary information has been entered. Pressing the Go! button
makes the address location appear on the map. If you choose Previous
Destination, the last 20 destinations you have selected appear.
2. Select Set as Dest to make this your destination. You can also choose
to set this as a waypoint (have the system route to this point on the
way to your current destination) or save it as a favorite. Any Avoid
Areas selections are also considered in route calculation.
MyFord Touch
ா (If Equipped)
439
2013 Focus (foc)
Owners Guide gf, 1st Printing
USA (fus)