BMW 650i Coupe 2006 - Manual (Page 199)

Replacing components
198
High beams, parking lamps
The illustration shows the front left side of the
engine compartment.
High beams
Bulb 55 watts, H 7
1. Remove the cover cap 1 by pressing the tab
and removing the cover cap upward.
2. Press the bulb holder from above to release
it.
3. Remove the bulb holder.
4. Remove and replace the bulb.
The lamp H7 is pressurized; wear eye
protection and protective gloves. Other-
wise, there is the risk of bodily injury if the lamp
is damaged.
<
Parking lamps
Bulb 10 watts
Bulb holder and reflector are one unit and
are replaced together.
<
1. Turn the bulb holder 2 to the right and
remove.
2. Press the snap connection on the plug con-
nector, pull off the bulb holder and replace.
Front turn signal, sidemarker
Your BMW is equipped with two turn signal
lamps per side in the front.
Turn signal lamp 1
Bulb 21 watts, WY 21 SV
The illustration shows the front right side of the
engine compartment.
1. Press the lever shown:
> downward for the right turn signal
> upward for the left turn signal
2. Remove the bulb holder towards the rear.
3. Remove and replace the bulb.
Turn signal lamp 2
Bulb 21 watts, WY 21 SV
The bulb for the turn signal lamp 2 can be
replaced via the wheel well.
The illustration shows the front left side of the
vehicle.
1. Turn the steering all the way to be able to
remove the cover, refer to illustration.
2. Turn off the light, switch off the ignition and
remove the remote control from the ignition
lock.
3. Unscrew the two bolts using the open-end
wrench from the onboard tool kit, refer to
page
197 .
Online Edition for Part-No. 01 41 0 159 709 © 09/05 BMW AG