BMW M5 Sedan 2008 User Manual

Page 33

inside is not possible without special knowl-
edge.

Switching on interior lamps

With vehicle locked:
Press the

button.

You can also use this function to locate your
vehicle in parking garages etc.

Panic mode*

You can trigger the alarm system in case of dan-
ger:
Press the

button for at least 3 seconds.

Switching off alarm: press any button.

Opening luggage compartment lid

Press the

button for approx. 1 second.

The luggage compartment lid opens, regard-
less of whether it was previously locked or
unlocked.

During opening, the luggage compart-
ment lid pivots back and up. Make sure

that adequate clearance is available before
opening.
To prevent accidentally locking yourself out,
never lay the remote control in the cargo bay. A
previously locked luggage compartment lid is
also locked again after closing.

Confirmation signals

You can activate or deactivate the confirmation
signals.

Open the start menu.

Press the controller to open the menu.

Select "Settings" and press the controller.

Select "Vehicle / Tires" and press the con-
troller.

Change to upper field if necessary. Turn the
controller until "Door locks" is selected and
press the controller.

Select "Confirmation" and press the con-
troller.

Select the desired signal.

Press the controller.

The signal is activated.

Malfunction

The remote control may malfunction due to
local radio waves. Should the remote control fail
to operate due to interference of this kind,
unlock and lock the vehicle via the door lock
using a key.
If it is no longer possible to lock the vehicle
using the remote control, then the battery is
discharged. Use this remote control during an
extended drive; this will recharge the battery,
refer to page

For US owners only

The transmitter and receiver units comply with
part 15 of the FCC/Federal Communication
Commission regulations. Operation is gov-
erned by the following:
FCC ID:
LX8766S
LX8766E
LX8CAS
LX8CAS2
Compliance statement:
This device complies with part 15 of the FCC
Rules. Operation is subject to the following two
conditions:

This device must not cause harmful inter-
ference, and

this device must accept any interference
received, including interference that may
cause undesired operation.