beautypg.com

Sun blinds, For rear window, Practical interior accessories – BMW 535i xDrive Sports Wagon 2009 User Manual

Page 124

background image

Practical interior accessories

122

You can operate the device when the engine is
running or when the ignition is switched on.

If the device fails to function even after
repeated programming, check whether

the original hand-held transmitter uses an alter-
nating-code system. To do so, either read the
instructions for the original hand-held transmit-
ter or hold down the programmed memory
button

1 of the integrated universal remote

control. If the LED

2 on the integrated universal

remote control flashes rapidly for a short time
and then remains lit for approx. 2 seconds, this
indicates that the original hand-held transmitter
uses an alternating-code system. In the case of
an alternating-code system, program the mem-
ory buttons

1 as described at Alternating-code

hand-held transmitters.

<

Alternating-code hand-held
transmitters

To program the integrated universal remote
control, consult the operating instructions for
the equipment to be set. You will find informa-
tion there on the possibilities for synchroniza-
tion.
When programming hand-held transmitters
that employ an alternating code, please observe
the following supplementary instructions:

Programming will be easier with the aid of
a second person.

<

1.

Park your vehicle within the range of the
remote-controlled device.

2.

Program the integrated universal remote
control as described above in the section
Fixed-code hand-held transmitters.

3.

Locate the button on the receiver of the
device to be set, e.g. on the drive unit.

4.

Press the button on the receiver of the
device to be set. After step 4, you have
approx. 30 seconds for step 5.

5.

Press the programmed memory button

1

of the integrated universal remote control
three times.

The corresponding memory button

1 is now

programmed with the signal of the original
hand-held transmitter.

If you have any additional questions,
please contact your BMW center.

<

Deleting all stored programs

Press the left and right-hand memory button

1

for approx. 20 seconds until the LED

2 flashes

quickly:
All stored programs are deleted.
Individual programs cannot be deleted.

Rememorizing individual programs

1.

Hold the original handheld remote control
approx. 4 in/10 cm to 12 in/30 cm away
from the memory buttons

1.

The required distance between the
hand-held transmitter and the mem-

ory buttons

1 depends on the relevant sys-

tem of the original hand-held transmitter
used.

<

2.

Press the desired memory button

1 of the

integrated universal remote.

3.

If the LED

2 flashes slowly after approx.

20 seconds, press the command button of
the original hand-held transmitter. As soon
as the LED

2 flashes rapidly, release both

buttons. If the LED

2 does not flash rapidly

after approx. 15 seconds, alter the distance
and repeat the step.

Sun blinds*

Sun blind for rear window

Press the button on the driver's door.

Online Edition for Part no. 01 41 2 600 721 - © 08/08 BMW AG