Comfort access – BMW X6 xDrive50i 2011 User Manual
Page 37
35
Indicator lamp displays
>
The indicator lamp under the interior rear-
view mirror flashes continuously: the sys-
tem is armed.
>
The indicator lamp flashes after locking: the
doors, hood, or liftgate are not properly
closed. Even if you do not close the alerted
area, the system begins to monitor the
remaining areas, and the indicator lamp
flashes continuously after approx.
10 seconds. However, the interior motion
sensor is not activated.
>
The indicator lamp goes out after unlocking:
your vehicle has not been disturbed while
you were away.
>
The indicator lamp flashes after unlocking
until the remote control is inserted into the
ignition lock, however for a maximum of
approx. 5 minutes: your vehicle has been
disturbed while you were away.
Tilt alarm sensor
The tilt of the vehicle is monitored. The alarm
system reacts, e.g. in case of an attempted
wheel theft or towing.
Interior motion sensor
In order for the interior motion sensor to func-
tion properly, the windows and glass sunroof
*
/
panoramic glass sunroof
*
must be completely
closed.
Avoiding unintentional alarms
The tilt alarm sensor and interior motion sensor
may be switched off at the same time. This pre-
vents unintentional alarms, e.g. in the following
situations:
>
In stacking garages
>
When transporting on car-carrying trains,
by sea or on a trailer
>
When animals are to remain in the vehicle
Switching off tilt alarm sensor and
interior motion sensor
Press the
button on the remote control
again as soon as the vehicle is locked.
The indicator lamp lights up briefly and then
flashes continuously. The tilt alarm sensor and
the interior motion sensor are switched off until
the next time the vehicle is unlocked and subse-
quently locked again.
Comfort Access*
Comfort Access enables you to access your
vehicle without having to hold the remote con-
trol in your hand. It is sufficient to carry the
remote control with you, e.g. in your jacket
pocket. The vehicle automatically detects the
related remote control in the immediate vicinity
or in the interior.
Comfort Access supports the following func-
tions:
>
Unlocking/locking vehicle
>
Convenient closing
>
Opening liftgate
>
Starting engine
Functional requirements
>
The vehicle can only be unlocked if the
vehicle detects that the remote control car-
ried is not located in the vehicle interior.
>
The next unlocking and locking cycle is not
possible until after approx. 2 seconds.
>
The engine can only be started if the vehicle
detects that the remote control is located in
the vehicle.
Online Edition for Part no. 01 41 2 604 009 - © 03/10 BMW AG
Online Edition for Part no. 01 41 2 604 009 - © 03/10 BMW AG