Bmw x6: changing lamps – BMW X6 xDrive50i 2011 User Manual
Page 267
265
3.
Apply gentle pressure to the bulb while
turning it to the left for removal and replace-
ment.
4.
Re-engage the bulb holder so that it audibly
clicks into place.
5.
Before installing the cap, unclip the cargo
area lamp.
Then lay the cap on its upper side and close
it, refer to arrow.
6.
Position the cargo area lamp and clip it in,
refer to arrow.
License plate lamp
5-Watt bulb, C5W
1.
Slide the lamp to the right with a screw-
driver, refer to arrow
1.
2.
Remove the lamp, arrow
2.
3.
Replace the bulb.
4.
Reinstall the lamp.
Center brake lamp
This lamp uses LED technology for operation.
In case of a defect, please go to a BMW Sports
Activity Vehicle Center or a workshop that
works according to BMW repair procedures
with correspondingly trained personnel.
BMW X6: changing lamps
Xenon lamps
These bulbs have a very long service life and
the probability of a failure is very low. If a lamp
should nevertheless fail, you can continue driv-
ing cautiously with fog lamps
*
provided that
this is permitted by the country-specific laws.
Have work on the xenon light unit includ-
ing changing the bulb carried out only by
your BMW Sports Activity Vehicle Center or a
workshop that works according to BMW repair
procedures with correspondingly trained per-
sonnel. Due to the high voltage present in the
system, there is a danger of fatal injuries when
work is carried out improperly.
<
Parking lamps and roadside parking
lamps, daytime driving lamps*
35-Watt bulb, H8
The bulb is pressurized. Therefore, wear
safety glasses and protective gloves.
Otherwise there is a danger of injuries if the
Online Edition for Part no. 01 41 2 604 009 - © 03/10 BMW AG
Online Edition for Part no. 01 41 2 604 009 - © 03/10 BMW AG