BMW X6 xDrive50i 2011 User Manual
Page 271
269
it from extending to its full support height and
reduce its load-carrying capacity.
To avoid serious or fatal injury: never lie under
the vehicle, and never start the engine while it is
supported by the jack.
<
What you will need
To avoid rattling noises later on, note the posi-
tions of the tools before removing them, then
return them to their initial positions after com-
pleting work.
The tools are located in the mount under the
floor panel flap.
1 Vehicle jack
*
2 Vehicle jack crank
*
3 Lug wrench
*
Removing compact wheel
The compact wheel is located in the cargo area
under the floor panel.
1.
Remove the tool mount.
2.
Unscrew the wing nut
1.
3.
Remove the washer
2 laterally.
4.
Remove the compact wheel.
Preparing wheel change
1.
Observe the safety precautions above.
2.
Loosen the lug bolts a half turn.
Jacking up vehicle
1.
Position the vehicle jack at the jacking point
closest to the wheel so that the entire sur-
face of the jack base rests on the ground
perpendicularly beneath the jacking point.
The vehicle jack is designed for
changing wheels only. Do not attempt
to raise another vehicle model with it or to
raise any load of any kind. To do so could
cause accidents and personal injury.
<
2.
Guide the jack head into the rectangular
recess of the jacking point when cranking
up, refer to illustration detail.
3.
Jack the vehicle up until the wheel you are
changing is raised from the ground.
Mounting a wheel
1.
Unscrew the lug bolts and remove the
wheel.
2.
Remove accumulations of mud or dirt from
the mounting surfaces of the wheel and
hub. Also clean the lug bolts.
Online Edition for Part no. 01 41 2 604 009 - © 03/10 BMW AG
Online Edition for Part no. 01 41 2 604 009 - © 03/10 BMW AG