EcoPure MW_MW30_450224 - Manual (Page 8)

8 Miracle Water Installation & Operation Manual
Assembly
1. Miracle Water models are factory assembled. During installation, remove the Salt Hole Cover. Set
aside to prevent damage. Check the brinewell to be sure it is secured and vertical (see Figure 1).
Slide Faceplate Cover forward to expose back valve assembly.
2. Lift the brine valve out of the brinewell. Be sure the float stem is parallel to stand tube so seals will
seat properly during operation. Replace the brine valve in the brinewell bottom and install the
Brinewell Cover.
3. Install the brine tank overflow grommet and elbow in the 13/16” diameter hole in the back of the
salt storage tank sidewall.