Dogtra RRD - Manual (Page 11)

DIAGRAM OF BACK VIEW TO LAUNCHER
BACK VIEW OF SPRING SETTINGS
To adjust spring strength settings, use a
flathead screwdriver and turn the bolt to
move the springs up and down.
Moving the springs from top to bottom
increases launch power : the very top being
lowest and the very bottom being highest.
Spring Adjustment Bolt
1) Check that all parts have been included.
2) Pull the solenoid cord through the hole in
the launcher box and plug it into the
receiver's outlet (Figure 4).
Figure 4. Plugging Solenoid cord into receiver.
ASSEMBLY AND
OPERATION
ASSEMBLY