Dogtra 1600 Series - Manual (Page 13)

22
CHARGING THE BATTERIES
23
TESTING
1. Turn the collar on by pressing the button
on the back side of the collar receiver. The
indicator light will come on for a moment
then blink once every two seconds,
showing that the collar is ready to use. (If
the indicator light is red, the batteries need
to be charged.) Place the test light on the
contact points of the receiver and hold it
there.
TESTING YOUR
COLLARS
Battery Charging Procedure
1. Attach the charging cables to both the
transmitter and receiver(s), as shown on
page 20.
2. Plug the charger into a 120-volt wall outlet
or, if using the accessory field charger,
plug into a cigarette lighter. (Use a 230-
volt European charger for Europe.) When
properly plugged in, all indicator lights
should glow red.
The receiver automatically turns off when
you insert the charging cable into the
battery-charging receptacle on the receiver.
3. After charging, cover the battery charging
receptacles with the rubber plugs on the
transmitter and receiver.
4. The battery is fully charged with a 14-hour
charge. The lights will stay red during the
charging process. They DO NOT turn
green when fully charged. Charging the
batteries for more than 14 hours at one time
will not extend battery life.