Compaq TFT5000 - Manual (Page 5)

English 1-3
Part Number: 325703-001- Writer: Marianne Silvetti - Saved by: MSilvetti
Saved date: 03/15/99 4:03 PM
File Path: P:\Docs\Monitors\Aoki
Setting Up the Monitor
To set up the monitor, ensure that the power is turned off to the
monitor, computer system, and other attached devices, then follow
these steps:
1. Place the monitor in a convenient, well-ventilated location near
your computer.
2. Connect the monitor signal cable 1 on the rear panel of the
monitor to the 15-pin connector on the rear panel of the
computer and tighten the screws.
Be sure the signal cable aligns with the 15-pin connector.
Do not force the cable onto the connector or you may
damage the signal cable.
3. Connect one end of the AC power cord 2 to the AC adapter and
the other end to an electrical outlet that is easily accessible and
close to the monitor.
CAUTION: When connecting the monitor, be sure to use the
AC adapter supplied with the monitor. Failure to use this
AC adapter may result in damage to the monitor.