Motorola SURFboard SBG901 - Manual (Page 17)

B
2 • Getting Started 16
2
Getting Started
This section provides information on setting up and installing the SBG901 wireless
gateway. For information on WLAN setup, see
Setting Up Your Wireless LAN .
Before You Begin
Before you begin the installation, check that the following items were included with your
Motorola SBG901 Wireless Cable Modem Gateway:
Item Description
Power cord Connects the SBG901 to an AC electrical outlet
10/100Base-T
Ethernet cable Connects the SBG901 to the network via the
Ethernet port. Cable must be Cat 5 or greater with an
RJ-45 connector.
Software License &
Regulatory Card Contains software license, warranty, and safety
information for the SBG901.
SBG901 Installation
CD-ROM Contains the SBG901 Installation Assistant, and this
user guide
SBG901 Install Sheet Provides basic information for setting up the SBG901
You must have the latest service packs and patches installed on your computer for your
operating system. You will need a 75-ohm
coaxial cable with F-type connectors to
connect the SBG901 to the nearest cable outlet. If a TV is connected to the cable outlet,
you may need a 5 to 900 MHz RF splitter
and two additional coaxial cables to use both
the TV and the SBG901.