CTEK Automation Control Application APN007 - Manual (Page 9)

Application Note – Automation Control Application
APN007 25 July, 2014
4
User Interface and Configuration Specifics
Selecting the Automation Control Configuration item presents the following menu from which the
user can install, configure, and adjust settings on I/O modules and sensors.
Note: System Errors indicates entries made as a result of this application since the last time the
box was restarted. System errors can be caused by a number of events but one common source
is communications problems with I/O modules. Contact Ctek or see TechNotes to recover the
system log contents.
Figure 3 - Automation Control Configuration Menu
Execute New Configuration
The Execute New Configuration button must be pressed before any changes made on any edit
screens will be deployed. The only exception to this rule is that outputs that are changed from
their Output edit screen will take effect immediately and do not require a New Configuration.
A new control panel view is also generated during a new configuration.
Unit Configuration
Selecting the Unit Configuration menu item causes the screen shown in Figure 4 to be displayed.
A description of each field follows the screen image.