Cooper Instruments & Systems Series M3 Digital Force Gage User Manual
Page 11
Series 3 Digital Force Gauges
User’s Guide
10
Restart the computer before connecting a Mark-10 USB device.
5. After Windows as restarted, plug in the device. The following will occur:
Windows 7 Operating Systems
– When the Mark-10 USB device has been plugged into a USB
port, the driver will automatically be found. When the driver installation is complete, a message
will appear as follows: “The MARK-10 USB DEVICE driver is now installed and ready to use”.
Non-Windows 7 Operating Systems
– When the Mark-10 USB device has been plugged into a
USB port, the following screen appears:
Select
“No, not this time”, then click “Next”.
6. The next screen appears as follows:
Select
“Install the software automatically (Recommended)”, then click “Next”.