Cooper Instruments & Systems TT03C Digital Cap Torque Gage - Manual (Page 17)

Series TT03 Digital Torque Gauges User’s Guide
16
Ensure that the load is not swinging, oscillating, or vibrating in any manner. Then try again.
The calibration load does not match the set value.
The entered calibration point is too close to the previous point.
11 OTHER SETTINGS
11.1 Automatic Shutoff
The gauge may be configured to automatically power off following a period of inactivity while on battery
power. Inactivity is defined as the absence of any key presses or load changes of 100 counts or less. To
access these settings, select Automatic Shutoff from the menu. The display will appear as follows:
Select Disabled to disable automatic shutoff. Select Enabled to enable it. The length of time of inactivity
is programmed in minutes via the Set Minutes parameter. Available settings: 5-30, in 5 minute
increments.
Note: If the AC adapter is plugged in, the gauge will ignore the Automatic Shutoff setting and remain
powered on until the POWER key is pressed.
CALIBRATION
COUNTER-CLOCKWISE
LOAD TOO CLOSE
TO PREVIOUS
PLEASE TRY AGAIN
LOAD NOT STABLE
PLEASE TRY AGAIN
CALIBRATION
CLOCKWISE
LOAD TOO LOW
PLEASE TRY AGAIN
AUTOMATIC SHUTOFF
* Disabled
Enabled
Set Minutes
5