BlueAnt X3 Micro Bluetooth Headset - Manual (Page 13)

Resetting your headset
Note: If you have paired the headset with 3 devices you cannot then enter into pairing mode as
the memory is full. If you want to pair your headset with another phone you must reset your
headset to clear the paired devices list. Resetting your headset clears all the current pairings. All
device data will be lost.
1. Short press and release all the three buttons on your headset together for less than 1
second. You will see the purple indicator quickly flash twice then the blue and red
indicator alternatively blink every second, your headset go into pairing mode automatically
after resetting. You can only reset your headset when it is in standby mode (please refer
to the LED indicator chart).
2. Pair the new Bluetooth device with your headset.
Function / Button matrix
Function / Button matrix
Function Button
Power on/off
Pair
Voice dial using the current connected phone when connected
Voice dial through the first paired phone when not connected
Cancel voice dialing
Cancel last call redial
Answer a call
End a call
Voice dial through the second paired phone when not connected
Voice dial through the third paired phone when not connected
Turn ON/OFF LED lights (disconnect from phone first)
long press for 3 seconds
long press for 3 seconds
short press 1 time
short press 2 times
short press 3 times
short press 5 times
23
24