ClearSounds TALK500 V508 - Manual (Page 6)

6 – ENGLISH 7 – ENGLISH
Connecting The power Supply
plug the AC adapter into the AC power Jack on the back of your
phone, then into an electrical outlet or surge protector, if you are
using one. For safety reasons, use only the AC120V DC9V 200mA
adapter provided. Note: The adapter is required for the telephone to
work correctly.
Hanging The phone on The Wall
1. Mount using an existing wall plate adapter or drill two holes
vertically, one above the other, 83mm apart, and leave the screws
protruding from the wall by 5mm.
2. press and lift out the handset holder. Remove the hanging peg
(located by the hook switch) by pushing it upwards and snap it
into place so it will hold the handset in place when the phone is
mounted on the wall.
3. Insert the mounting bracket’s two tabs into the matching slots
opposite the keyhole slot on the underside phone’s base. Then press
down and slide the bracket upward until the tabs snap into place.
4. plug one end of the telephone line cord into the TEL. LINE jack at
the back of the base.
5. plug the cord’s other end into the wall plate jack, then align the base’s
keyhole slots with the screws and slide the phone downward to secure it.
SETTING Up
Setting The Contrast
1. press the MENU button. The display shows LCD CoNTRAST.
2. press the DIAL button. The display shows the current contrast
setting with values between 1 and 5.
3. press or to select the contrast level and confirm with DIAL button.
4. The display now shows to ENTER TIME/DATE, you can refer to next
section to set the time and date or press button to exit the set-
up mode.
Note: You can select the desired LCD function by pressing the number
key. For example: You can press MENU button, then press 5 digit, NAME
RECORDING will show.
Setting The TIME And DATE
1. press and release the MENU button until ENTER TIME/DATE is shown.
2. press the DIAL button. The display shows ENTER TIME and the
hours digits is flashing.
Talk500-TriLingual.indd 6 5/8/08 12:09:21 PM