beautypg.com

Installation installing batteries, Connecting the telephone – ClearSounds TALK500 V508 User Manual

Page 5

background image

4 – ENGLISH

5 – ENGLISH

on top of a TV or VCR; and, if interference is experienced, moving

the cordless telephone farther away from the TV or VCR will often

reduce or eliminate the interference. However, there is no guarantee

that interference will not occur in a particular installation. If this

equipment does cause harmful interference to radio or television

reception, which can be determined by turning the equipment off

and on, the user is encouraged to try to correct the interference by

one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from

that to which the receiver is connected.

• Consult the dealer or an experienced radio TV technician for help.

INSTALLATION

Installing Batteries

Your telephone requires four AA batteries (not supplied) in case of

network power failure for LCD backup & operations. When appears

on the display or the display dims, replace the batteries with 4 AA

fresh ones. Note: Should you choose not to install batteries - the

telephone numbers in memory and the voice recordings are stored

in non-volatile flash memory and will not be lost.

Before opening the battery compartment, make sure the telephone

1.

is disconnected from the telephone line and the power supply.

2. Use a flat-blade screwdriver to lift the battery compartment

door.

3. Insert 4 AA batteries into the compartment as indicated by the

polarity symbols. Never mix battery types (different chemistries,

brands and/or fresh vs. used).

4. Snap the battery compartment door back into place.

Connecting The Telephone

1. plug one end of the telephone line cord into the TEL.LINE jack at

the back of the telephone base.

2. plug the other end of the telephone line cord into the wall outlet.
3. plug one end of the coil cord into the handset’s modular jack.
4. plug the other end of the coil cord into the left side of the

telephone base.

Talk500-TriLingual.indd 5

5/8/08 12:09:21 PM