ClearSounds TALK500 V508 - Manual (Page 10)

10 – ENGLISH 11 – ENGLISH
put a call on hold and take a second incoming call on the same
line by pressing CALL WAITING button. press CALL WAITING again to
alternate between the two calls.
Note: If you do not have any special phone services requiring a
switch-hook signal, pressing CALL WAITING might disconnect the
current calls.
Message Waiting Indicator
If you have Voice Mail Service from your local phone company, when
you are unable to answer a call, the incoming call will be forwarded
to a mailbox where the caller can leave a message. Your Talk500 will
display MESSAGE WAITING if a recorded message has been left. The
New Call LED will blink until the message is retrieved.
or you can press the DELETE button once, the display shows DELETE
?, press and hold the DELETE button to turn oFF the New Call LED
and the MESSAGE WAITING message.
Note: Subscription is required to use the Message Waiting services.
Hearing Aid Compatibility
This unit is compatible with inductively coupled hearing aids and
cochlear processors. Adjust your hearing aid’s or processor’s “T-switch”
to the “T” position. Make sure to hold the handset close to your hearing
aid or processor.
THE pHoNE BooK
Important: When using the phone book features, please note it is only
available at phone book mode ( icon turns on). If the icon is off,
press button once.
Storing numbers in the phone book
(Can be stored up to 30 lists)
1. press and release the MENU button until SToRE NUMBER is
shown.
2. press the DIAL button. The cursor will flash in the first position.
3. Enter the required telephone number with a maximum of 22
digits using the number pad and confirm with DIAL button.
4. Enter the required name with a maximum of 16 letters. The next
section will tell you how to enter names.
5. Confirm with DIAL button. The display now shows NAME
RECoRDING.
Talk500-TriLingual.indd 10 5/8/08 12:09:22 PM