Bio-Rad GS-800™ Calibrated Densitometer User Manual

Page 5

1.3 Safety

The Model GS-800 Calibrated Imaging Densitometer system uses high voltage and high
current and should be operated with care at all times. To avoid shock, set up the GS-800
Densitometer in a dry area. Immediately wipe up any spilled solutions.

• Turn off the Densitometer, and then disconnect the power plug when you want to

clean the Densitometer case or glass plate, or when the Densitometer needs service or

repair.
• Place the Densitometer on a level surface.
• To ensure proper ventilation, allow a minimum of 15 cm free space around each side of
the

Densitometer.

• Do not leave photographs, gels, or film on the glass plate for excessive periods of time.

The heat from the light source in the Densitometer may cause them to deteriorate.

• Do not operate the Densitometer when the environmental temperature falls below 5° C

or rises above 40° C.

• Do not operate the Densitometer when the environmental humidity falls below 20% or

rises above 85%.

1.4 Regulatory Compliance*

Declaration of Compliance
The party responsible for product compliance
Corporate Name: UMAX Technologies, Inc.
Address:

Techville, Inc.
11343 N. Central Expwy

Dallas, TX 75243 USA

Telephone No.:

Tel.: (214) 739-7033

*See UMAX PowerLook 2100XL Operation Manual