B&G V90 VHF Radio - Manual (Page 21)

| 21
Installation | V90 Installation Manual
Transceiver external connectors
VHF antenna
A suitable radio antenna (not supplied) must be mounted and
connected with a PL259 connector before you can operate the
radio. Consult your B&G dealer for advice, if necessary.
Always mount the VHF antenna as high as possible and at least 1 m
(39 inches) from the transceiver.
NMEA 2000 (N2K) connector
The V90 radio can be connected to an NMEA 2000 network using
a cable (not supplied). For further information, see “NMEA 2000
Network” on page 26.
¼ Note: A GPS source is required to enable full functionality of DSC
calling, especially DISTRESS calls.
Transceiver internal connectors
To access the internal connectors, remove the cover plate by
unscrewing the captive screws. The connectors are on the internal
circuit board, which is located as shown below.
Internal
connector
blocks