Apricorn SATA Wire 3.0 - USB 3.0 Interface to any 2.5" SATA Drive - Manual (Page 5)

8 9 www.apricorn.com www.apricorn.com
Connecting Your Hard Drive
EZ Gig
Start Up Options
Depending on how you received EZ Gig, you have two options.
1. If you have EZ Gig on a CD, please choose the Start option (proceed
to page 11 of this manual to continue).
2. If you downloaded EZ Gig from Apricorn’s website, you can either
choose the Start option (go to page 11) or create a bootable EZ Gig
CD to use in the future (go to page 10 for instructions).
Before starting the EZ Gig software,
please ensure that your new hard drive
is connected to your notebook’s USB
port via one of Apricorn’s Upgrade
products listed on the previous page.
Creating a Bootable EZ Gig CD
If you downloaded EZ Gig from Apricorn’s website, you have the option
of creating a bootable EZ Gig CD or thumb drive to use in the future.
To create a bootable media disk follow the appropriate directions below:
• To create a bootable CD/DVD, choose the desired drive at ‘CD/
DVD writer’ and click “Create CD/DVD”.
• To create a bootable USB key, choose the desired drive at ‘USB
medium’ and click “Make bootable”.
Follow the instructions and wait until the installation program reports
successful creation of the bootable medium.
Once you have created you bootable media device, click “Exit” and then
choose “Start EZ Gig”.