Apricorn Aegis Padlock DT FIPS - USB 3.0 Desktop Drive - Manual (Page 2)

Locking the Drive
To lock the drive, press the Cancel button.
If data is still being written to the drive, the Padlock DT will wait until all data has been written to
the drive and then it will lock automatically.
Note: The Aegis Padlock DT will not be recognized by the operating system in the standby state.
Unlocking the Drive
To unlock the drive, enter either a User PIN or Admin PIN and press the UNLOCK button.
Adding a new User PIN
Performing a Complete Re-Set
Apricorn provides the following helpful resources for you:
1. Apricorn’s Website ( http://www.apricorn.com)
This gives you the ability to check for up-to-date information
2. E-mail us at [email protected]
3. Or call the Technical Support Department at 1-800-458-5448
Apricorn’s Technical Support Specialists are available from 8:00 a.m.
to 5:00 p.m., Pacific Standard Time Monday through Friday
Technical Support
1. Enter the Admin Mode ( UNLOCK + 0 for five seconds. Enter Admin PIN and press UNLOCK).
2. Press and hold UNLOCK + 1 until the LED turns to Solid BLUE and Blinking GREEN .
3. Enter a User PIN and press UNLOCK (a minimum of 7 digits and a maximum of 16 digits).
The LED flashes GREEN three times, then returns to Solid BLUE and Blinking GREEN .
4. Re-enter the new User PIN and press UNLOCK. If the LED stays solid GREEN for two
seconds and then solid BLUE , the User PIN was successfully added.
To perform a complete reset of the drive, do the following:
1. Turn OFF the Aegis Padlock DT using the switch on the back of the drive. Press and
hold the Cancel button while you turn the switch ON. The LED will flash RED , GREEN
and BLUE alternately.
2. Press and hold Cancel + UNLOCK + 2 for 10 seconds until the LED turns Solid GREEN
for two seconds, followed by Solid BLUE and Solid GREEN . You have successfully
reset the Aegis Padlock DT.
Formatting the drive
The Aegis Padlock DT comes preformatted in NTFS for Windows ® and is ready for use. For the
Mac OS the Disk Utility should be used to reformat the hard drive to a Mac compatible file system.
(Rev 1.2) 4/7/2014
Locking the Drive
To lock the drive, press the Cancel button.
If data is still being written to the drive, the Padlock DT will wait until all data has been written to
the drive and then it will lock automatically.
Note: The Aegis Padlock DT will not be recognized by the operating system in the standby state.
Unlocking the Drive
To unlock the drive, enter either a User PIN or Admin PIN and press the UNLOCK button.
Adding a new User PIN
Performing a Complete Re-Set
Apricorn provides the following helpful resources for you:
1. Apricorn’s Website ( http://www.apricorn.com)
This gives you the ability to check for up-to-date information
2. E-mail us at [email protected]
3. Or call the Technical Support Department at 1-800-458-5448
Apricorn’s Technical Support Specialists are available from 8:00 a.m.
to 5:00 p.m., Pacific Standard Time Monday through Friday
Technical Support
1. Enter the Admin Mode ( UNLOCK + 0 for five seconds. Enter Admin PIN and press UNLOCK).
2. Press and hold UNLOCK + 1 until the LED turns to Solid BLUE and Blinking GREEN .
3. Enter a User PIN and press UNLOCK (a minimum of 7 digits and a maximum of 16 digits).
The LED flashes GREEN three times, then returns to Solid BLUE and Blinking GREEN .
4. Re-enter the new User PIN and press UNLOCK. If the LED stays solid GREEN for two
seconds and then solid BLUE , the User PIN was successfully added.
To perform a complete reset of the drive, do the following:
1. Turn OFF the Aegis Padlock DT using the switch on the back of the drive. Press and
hold the Cancel button while you turn the switch ON. The LED will flash RED , GREEN
and BLUE alternately.
2. Press and hold Cancel + UNLOCK + 2 for 10 seconds until the LED turns Solid GREEN
for two seconds, followed by Solid BLUE and Solid GREEN . You have successfully
reset the Aegis Padlock DT.
Formatting the drive
The Aegis Padlock DT comes preformatted in NTFS for Windows ® and is ready for use. For the
Mac OS the Disk Utility should be used to reformat the hard drive to a Mac compatible file system.
(Rev 1.2) 4/7/2014