Aphex 188 Eight Channel Mic Preamp - Manual (Page 9)

188
Exit Configure
Press the encoder in and the display will change to the
metering screen.
Rear Panel
Microphone Inputs
Each microphone input is a locking female XLR (pin #1 ground, pin # 2 ‘+’ and
pin # 3 ‘-‘). Maximum input level is +21dBu with Pad engaged and the input
gain at 26dB.
Line Level Output
The channel outputs appear on a 25 pin D-Sub female connector using the Tas -
cam analog standard pin out. Maximum output level is fixed at +21dBu. Note:
The analog output of each channel can be internally ( See page 15) selected to
be either ‘post’ or ‘pre’ variable gain amplifier. In the ‘post’ mode the output
will be affected by the Pad, Low Cut and Polarity Reverse as well as the vari-
able gain amplifier. In the ‘pre’ mode the output will be affected by everything
except the variable gain amplifier. The ‘pre’ mode is useful to feed a monitor
console.
ADAT Outputs 1 and 2
Each Toslink connector will output standard ADAT (audio channels 1 through
8) when SMUX is not selected. When SMUX is selected ADAT Output 1 will
have audio channels 1, 2, 3 and 4; and ADAT Output 2 will have audio channels
5, 6, 7 and 8.
Page 9 Aphex Model 188