Chief Manufacturing Universal Slat Wall Multi Arm Mount KSY220 - Manual (Page 6)

KSY220 Installation Instructions
6
Figure 4
1
(J) X 2
(M) X 2
(A) X 2
(N) X 2
(L) X 2
(P) X 2
2
3
4
(K) X 4
Display Installation
The mounting holes on the back of the display will be flush with
the back surface, or recessed into the back. Refer to the
applicable installation procedure below.
Flush Mount Display Installation
CAUTION: IMPROPER INSTALLATION CAN LEAD TO
DISPLAY FALLING CAUSING SERIOUS PERSONAL
INJURY OR DAMAGE TO EQUIPMENT! Using screws of
improper size may damage your display! Proper screws will
easily and completely thread into display mounting holes.
CAUTION: IMPROPER INSTALLATION CAN LEAD TO
DISPLAY FALLING CAUSING SERIOUS PERSONAL
INJURY OR DAMAGE TO EQUIPMENT! Inadequate thread
engagement in display may cause display to fall! Back out
screws ONLY as necessary to allow installation of Centris
bracket!
1. Ensure Centris cup is able to swivel and tilt easily, yet still be
tight enough to hold display in desired position. Adjust as
required before proceeding. See "ADJUSTMENT" for
detail.
2. Using Phillips screwdriver, carefully install two screws (Q3)
into the upper mounting holes on the display. Thread
screws completely into display, then back out 3 complete
turns.
3. Align two screws (Q3) (installed on the back of the display
in the previous step) with the two top teardrop mounting
holes on the Centris cup.
CAUTION: IMPROPER INSTALLATION CAN LEAD TO
DISPLAY FALLING CAUSING SERIOUS PERSONAL
INJURY OR DAMAGE TO EQUIPMENT! Smaller area of
teardrop mounting holes must be facing downward for proper
installation. Reposition Centris cup if required.
Figure 5
4. Using Phillips screwdriver, install two screws (Q3) through
the lower mounting holes in Centris cup into the display.
5. Tighten all screws (Q3). Do not overtighten!
(Q3) x 2
Centris Cup
3
2