Amico TTS Vertical Flat Wall - Manual (Page 14)

14 Amico Beds
On / Off Switch
Compressor Gauge
&
Compressor Pressure Knob
Turn the power switch on the air compressor ON. The switch is located above the tank gauge. Once the air
compressor has been turned ON, use the Compressor Pressure Knob to change the pressure of the compressed
air being released to 50psi. The Compressor Gauge shall indicate the pressure.
CAUTION: Users shall now connect all power cords to electrical outlets, however ensure that all power switches
are in the OFF position until instructed to do so.
9.