Amico TTS Vertical Flat Wall - Manual (Page 11)

Install the Horizontal Vacuum Slide by holding the lever in and place the vacuum slide at an angle so that the
Vacuum Slide fits into the rail of the Teaching Solution. Continue to hold the lever and place the vacuum slide
in the upright position and then release the lever. This shall allow the horizontal vacuum slide to remain
upright securely. In order to remove the horizontal vacuum slide from the Teaching Solution, hold the lever,
tilt and gently tug the vacuum slide off the rail.
When installing the Vertical Vacuum Slide on the Teaching Solution, ensure that the vertical Vacuum Slide is in
the open position (unscrewed). Place the vertical vacuum slide onto the side rails of the Flatwall. Once in, turn
the knob on the side to securely fasten the vacuum slide into position. If done correctly, the vertical vacuum
slide shall sit securely on the Teaching Solution. In order to remove the vacuum slide, unscrew the black knob
found on the side until it is loose and remove.
www.amico.com 11
3.
4.