Cannon CANTFS-03-NG - Manual (Page 8)

8
Flame characteristics
The heater flame should be stable, no lifting from the burner and the logs
should glow after approximately 15 minutes operation on HIGH setting.
The heater is a fuel effect unit and is designed to operate with luminous
flames and may exhibit slight carbon deposits on the logs. If there is any
excess carbon build-up on the logs, or the burner flame is unstable, contact
Sampford IXL in your state. (See phone contact on page 21.
For service to this appliance refer page 21 for contact details.
Cleaning.
All cleaning should be carried out when the heater is cold. Normally the
heater should only need wiping with a lint - free damp cloth. Any stubborn
stains can be removed with a non-abrasive spray on cleaner. If an abrasive
cleaner is used the paint finish will be damaged.
Internally the heater should only be cleaned by a licensed service person
listed in this manual.
If your heater requires attention contact your supplier or licensed service
person listed in this manual.
Important:
The appliance should be inspected before use and at least annually by an
authorised service person. More frequent cleaning may be required due to
excessive lint build-up from carpeting, bedding materials, pet hair, etc.
It is imperative that the control compartment and circulating air passage
ways of the appliance be kept clean.
Do not use this fire if the glass is cracked or with the glass safety screen
removed.
Do not use fire with broken or missing logs.
17
26
Flue installation - Standard flue kit