Great Plains CP1000 Operator Manual - Manual (Page 18)

16
Section 2 Operating Instructions
CP1000 Three-Meter Drill and Hitch 148-358M 7/5/2005
Great Plains Mfg., Inc.
Parking
Perform the following steps when parking implement.
Refer to Storage, “Maintenance and Lubrication,” page
35, for information on long-term storage preparation.
1. Park implement on a firm, level area. Lower coulters
and drill to ground.
2. Block tires securely to prevent rolling.
3. Release pressure on hydraulic system, then discon-
nect hydraulic lines. Check that hose ends do not rest
on ground.
4. Move jack from transport position and place it on stob
on side of hitch tongue.
5. Extend jack until all weight is off tractor drawbar. Re-
move 1-by-10-inch bolt, washer and nut.
6. Disconnect implement light harness.