Great Plains P18432A Operator Manual - Manual (Page 15)

15 SLD
Operating Instructions
2.3 Installation
When carrying out installation and mainte-
nance work there is a higher risk of injury.
It is important that you familiarise yourself
with the machine and read the Operating
Instructions beforehand.
Operator instruction and initial installation of
the machine are carried out by our service
technicians or authorised distributors.
The machine must not be used in any way
beforehand! The machine can only be re-
leased for operation after instructions have
been provided by our service technicians or
authorised distributors.
• If any modules or parts have been removed
for transportation, these shall be mounted by
our service technicians/authorised dealers
before the instruction takes place.
• Check all important screw connections!
• Lubricate all nipples and joints!
• Check all hydraulic connections and lines
for damage.
2. Transportation and
Installation
Transportation and initial installation of the
machine are described in this chapter.
2.1 Delivery
The machine is normally delivered, fully
assembled.
• The machine can be lifted off with a crane
or other suitable lifting equipment.
• The machine should be hitched to a tractor
and driven off a low-loader.
2.2 Transportation
The SLD can be transported on public
roads by hitching it up to a tractor or on a
low-loader.
• It is important to observe the permitted
dimensions and weights when transporting
the machine.
• If the machine is transported on a trailer or
a low-loader, it must be secured using straps
or other devices.
• Before transporting the machine on public
roads, it must be adjusted to its transporta-
tion position and the stipulations relating to
road transportation fulfilled.
The transportation width can vary
according to the adjustment of
working parts (eg. discs, roll, etc).
It may be necessary to adjust the-
se elements in order to achieve
the minimum transport width.
Adjustments, including the attach-
ment of transport devices, should
be made at ground level; lowering
the machine may be necessary to
achieve this.
• The maximum permissible speed is 25
km /h.
2. Transportation / Installation