Great Plains 1006 Assembly Instructions - Manual (Page 3)

8/2/2005 151-118M
Great Plains Mfg., Inc.
3 Installation Instructions
Refer to Figure 2
7. Assemble and route the chain (1) from the
sprocket (2) on the drive bracket to the
sprocket on the small grass seed box (3). Ad-
just idler (4) to remove chain slack.
NOTE: With fertilizer and/or seed box agitator op-
tions already installed, a large portion of the drive
is already completed.
With Fertilizer
Refer to Figure 2
8. Add 17 tooth sprocket (5) to the fertilizer box
shaft. Assemble and route chain (6) from
sprocket (5) to the sprocket (7) on the drive
bracket. Adjust idler (8) to remove chain
slack.
With Seed Box Agitator
Refer to Figure 3
9. Remove the current bolt and hardware from
the rear hole of the seed box and install the
agitator idler bolt (2), jam nut, flat washer and
idler sprocket (3) into the rear hole of the false
end panel on the left-hand side of the seed
box.
Refer to Figure 4
10. Replace the agitator drive chain with the long-
er one provided. Route chain as shown and
adjust idlers to remove chain slack.
11. Attach the chain guards and the handles re-
moved in 3 to the mounting brackets using the
hardware removed in step 3 on page 2.
22557
21831
22558
Figure 2
Chain Routing
Figure 3
Idler Sprocket
Figure 4
Chain Routing