Great Plains 4000TM Assembly Manual - Manual (Page 30)

26 1800-3000TM Table of Contents Index Great Plains Manufacturing, Inc.
586-536E Table of Contents Index 04/12/2013
Wing Gang Bar 3000
Note: Refer to center gang bar assembly in “Parts Man-
ual” for correct part numbers of all components.
Refer to machine layout drawings in this manual
for correct gang assembly placement.
Refer to Figure 22
95. Position gang assemblies, front
and rear in
proper locations. Install the gang pivot bolt
through tubes of gang bars and tubes on center
frame, secure with 1 1/4 flat washers
(one on top
and one on bottom), 1 1/4 slotted nut (one on top
and one on bottom). Tighten bolts snug, torque to
350 to 400ft-lbs. Install the 3/16 x 2 cotter pins
through 1 1/4 slotted nut
and bend over to secure.
Note: Be sure turnbuckle assembly is preset at 62”
before installing as shown below. See gang angle
adjustment in “Operator Manual” before going to
field.
96. Install turnbuckle assemblies , adjustable end on
ear on front of rear gang bars and fixed end on ear of
front gang bars. Secure with 1 x 3 1/4 clevis pin
,
1.5 x 1.00 x 0.075 machine washer and 3/16 x 2
cotter pin .
97. Install the round tubes (two on each gang bar)
between bottom front plate (slotted hole toward
rear), rear plates and plates on wing frame. Install
the 3/4 x 6 hex bolts , 3/4 lock washers and 3/4
nuts. Attach other ends of plates and to bottom
of wing frame with 3/4 x 2 hex bolts and 3/4 lock
washers.
98. Install bracket on bottom side of gang bar plate,
secure with 5/8 x 3 1/2 hex bolts , 5/8 lock wash-
ers and 5/8 nuts.
99. The 3.50 x 2.5 x 1.25 gang cylinders and 3.25 x
2.5 x 1.25 gang cylinders may be hooked up with
the 1 x 3 1/8 clevis pin , 1.5 x 1.00 x 0.075
machine washer and 3/16 x 2 cotter pin .
100.Hook gang cylinder hoses to gang cylinders, be sure
all fittings are tightened to specs, See “Hydraulic
Connector ID” on page 40. Now the gang system
may be purged of air, See “Purging Hydraulic Sys-
tem” on page 19.
101.Bolt may be tightened to specs, See “Torque Values
Chart” on page 38 and all cotter pins may be bent.
1 2
3
4
5
6
5
7
7
8
9
6
12
10
11
13
10 11
14
15
16
17
18
19
9 6