Great Plains 80303P - Manual (Page 2)

2 Planter Digital Acre Counter 402-147M 4/8/14
Great Plains Mfg., Inc.
Assembly
2. Mount sensor on mounting bracket us-
ing hardware in this order: round-head
screws, flat washers, sensor, mounting
bracket, lock washers and nuts. Con-
nect ground wire from sensor to screw
between bracket and lock washer.
3. Mount bracket on inside of drive-tower
wall through existing hole using 5/16-
inch, hex-flange bolt and lock nut. Posi-
tion sensor so that gap between sensor
and magnet housing is no greater than
1/8 inch.
4. Route sensor lead down behind cross-
bar. Secure lead to crossbar using ca-
ble tie. Coil up excess lead and secure
under hydraulic lines using cable ties.
18026
18029
18030