Great Plains ADC1150 Operator Manual - Manual (Page 15)

13
Section 1 Preparation and Setup
6/15/05 ADC1150 Air Drill Cart 167-101M
Great Plains Mfg., Inc.
For Use with ADI Implements
1.
Connect auger/fold hoses. Auger/fold hoses go to the
diverter valve on the inside of the left tongue rail.
2. Connect lift hoses. Lift hoses are the 3/8-inch hoses
that go directly to the lift couplers on rear of cart.
3. Connect fan hoses. If your tractor has a priority circuit
for hydraulic motors, connect hoses to this circuit.
a. Hook 1/2-inch hose (1) shown in Figure 1-6 to the
outlet you choose to be the pressure side of cir-
cuit.
b. Hook 3/8-inch hose to other outlet.
NOTE: Fan hoses are not the same size. A 1/2-inch and a
3/8-inch hose are paired together.
Figure 1-6
Hydraulic Hook-Up for Older Carts with ADI
c. Connect 1/2-inch sump hose (2) shown in Figure
1-6 to the tractor hydraulic reservoir. Refer to your
tractor operator’s manual for instructions.
NOTE: For proper hydraulic flow, use a poppet-style, Pio-
neer quick coupler to connect sump hose to tractor. See
Figure 1-4.
16563
1
2